How to? Lighting Window
#1
Question 
Dear Garth,

I am a newbie using XenoDream 2.6 running under Windows 7 Pro and slowly working through the “Using XenoDream 2.6” manual.

1 - I followed the steps described in Section 2.2 of the Using XenoDream 2.6 manual to create an object: Constructor - Boxed / Tile - Archx.
2 - In the Rendering Tab, I set the width to 4,800 and the height to 3,600.
3 - I clicked on Render New.
4 - I clicked on Picture. The Picture Window appeared. Rendering was progressing.
5 - I waited till the rate was about 100 and clicked on Stop Render.
6 - I clicked on Lighting. The Lighting Window appeared. BUT, EXCEPT FOR THE BACKGROUND COLOR, NOTHING SHOWED IN THE SMALL WINDOW INSIDE THE LIGHTING WINDOW.
7 - I clicked on Apply. In the Picture Window, the shape with the selected background (yellow) showed.
8 - In the Picture Window, I clicked on File and on Save Pars and Picture. I saved both.
9 – Using Corel PSP, I opened the JPG file. Looked good!

My question is about step # 6 (above). In the small window inside the Lighting Window,
only the background color appeared. Is that right?

Thank you!

Doctor T
Reply


Messages In This Thread
Lighting Window - DoctorT - 07-11-2017, 01:32 AM
RE: Lighting Window - Garth Thornton - 07-11-2017, 07:12 AM

Forum Jump: